Manx SA7x Guía de instalación descargar pdf (Pagina 94)

4.2 Single-Host Installation of an SF3xx Storage Array

4.2.3.1 Completing the System Conﬁguration Sheet (Single-Host)

At this time, you should be ready to ﬁll out the system conﬁguration sheet.

Examples of these sheets are shown in Section 1.5 and in the KFMSA Module

Installation and User Manual (EK–KFMSA–IM).

Refer to these examples when ﬁlling out the system’s conﬁguration sheet.

Note

Do not attempt to ﬁll out and place the labels until you have completed

the system conﬁguration sheet.

The information from the system conﬁguration sheet is used to ﬁll

out the labels correctly for all DSSI cables, enclosure OCPs, and

subsystems.

You can also refer to the inside cover of the SF Family Label Booklet

(part number 36–32882–01) for instructions on how to ﬁll out the

labels.

4.2.3.2 Filling Out the Labels (Single-Host)

There are two sizes of labels: the larger one for the DSSI cables, and the

smaller one for the inside of the SF7x OCP door and the system I/O panel.

Refer to the inside cover of the SF Family Label Booklet (part number 36–

32882–01) for instructions on what information to put on each of the two types

of labels.

See Table 4–2 for the single-host conﬁguration on the SF7x OCP door, the front

panel of the magazine tape subsystem, and all DSSI cables.

Table 4–2 Single Host Colored Labels for the SF72 OCP Door

Label Color Port Position

Blue Port 1 SF1 and SF3 and TF1

Red Port 2 SF2 and SF3 and TF2

Yellow Port 3 SF4 and SF6 and TF3

Green Port 4 SF5 and SF6 and TF4

SF3 and SF6 are in split-bus mode.

4–10 Installing an SF3xx Storage Array to a VAX 6000 System

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 94