Manx SA7x Guía de instalación descargar pdf (Pagina 52)

3.5 Mounting the Half Bezel

The half bezel is utilized when mounting only one tape loader or odd numbers

of tape loaders. Mount the half bezel using the following procedure:

1. Mount the half bezel bracket to the inner side of the tape loader.

2. Mount the tape loader to its ﬁnal position.

3. Set the lower edge of the half bezel in place, aligning the slots in each

bottom corner of the bezel over the tabs of the clear plastic grille mounting

brackets.

4. Snap the upper portion of the half bezel in place, pushing the bezel top into

the top tabs of the clear plastic grille mounting brackets.

3.6 Removing and Replacing the OCP

To remove the storage element OCP:

1. Grasp both sides of the OCP and pull straight out.

2. Set OCP aside until disk or tape drive installation is complete.

To replace the storage element OCP:

1. Grasp both sides of the OCP.

2. Align the connector on the back of the OCP with the socket on the storage

element.

3. Push the OCP gently into place, ensuring that the plastic tabs and spring

clip on the OCP are seated in the bezel casting slots on the storage

element.

Note

This is valid only for RA9x disk drives.

The OCP should be at the top of the disk drive. If it is at the bottom,

remove the OCP by gently pulling it straight out. Turn the OCP around

and replace it in the top position. There may be a bezel connector cap

over the top OCP connector slot. If so, remove the cap before trying to

replace the OCP. Move the cap to the bottom connector slot, as shown in

Figure 3–2. The OCP of the tape drive should be on the right-hand site.

3–10 Preparation and Installation

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 52