Manx SA7x Guía de instalación descargar pdf (Pagina 53)

3.7 Removing and Replacing the Cabinet Top Cover

Remove the cabinet top cover using the following procedure:

1. At the rear of the cabinet, remove the two serrated, truss-head, Phillips

screws from the underside of the rear bustle. Save these screws.

2. Lift the cabinet top cover up, then slide it back approximately 1 to 1–1/2

inches. This will enable the metal tabs on the cover to clear the cabinet

H-stiffener slots.

3. Carefully remove the top cover from the cabinet and store in a safe place to

avoid damage to the painted ﬁnish.

Replace the cabinet top cover using the following procedure:

1. Lift the top cover over the cabinet and rest it on the H-stiffener.

2. Align the top cover metal tabs with the two slots in the top of the cabinet

H-stiffener.

3. Slide the metal tabs into the slots.

4. Push the top cover forward until the screw holes in the top cover align with

the holes in the rear bustle. The top cover now should be ﬂush with the

cabinet side panel proﬁles (top and front).

5. Insert and secure the two previously removed truss-head screws.

3.8 Removing and Replacing the Cabinet Rear Access Panel

Many products use a rear bustle assembly with a rear access panel secured

with two quarter-turn hex fasteners, as shown in Figure 3–3.

To remove this type of rear access panel, perform the following procedure:

1. Unlock the two hex fasteners located at the top of the panel with a

counterclockwise one-quarter turn.

2. Tilt the panel toward you, and lift it up to disengage the pins at the bottom

of the panel.

3. Lift the panel clear of the cabinet system.

To replace the rear access panel:

1. Lift the panel into place and ﬁt the pins into the holes at the top of the I/O

bulkhead.

2. Push the top of the panel into place and turn the two hex fasteners

one-quarter turn clockwise.

Preparation and Installation 3–11

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 53