Manx SA7x Guía de instalación descargar pdf (Pagina 306)

D.2 DSSI VAXcluster Installation of an DECarray

Note

A DSSI VAXcluster bus can only be connected from a VAX 4000 to a

single DECarray and then to another VAX 4000.

For a VAX 4000 Model 200, DSSI bus 0 connect to ports 1 and 9 on the

DECarray. The ﬁrst KFQSA adapter connects to port 2 and 10. The second

KFQSA adapter connects to port 3 and 11.

For a VAX 4000 Model 300, DSSI bus 0 and 1 connect to ports 1, 2 and 9, 10 on

the DECarray. The ﬁrst KFQSA adapter connects to port 3 and 11. The second

KFQSA adapter connects to port 4 and 12.

This section provides the procedures for installing the DECarray in a DSSI

VAXcluster conﬁguration correctly and safely. Digital Multivendor Customer

Services or trained installing personnel must perform the procedures.

Make sure that all precautions for site preparation have been completed. Refer

to DECarray installation guide.

The following procedures provide the steps to:

• Inspecting the array for proper conﬁguration (Section D.2.1)

• Cable the DECarray with an existing VAX 4000 Model 300 system in the

DSSI VAXcluster conﬁguration (Section D.2.2)

• Verify the DECarray for correct operation (Section D.2.3)

D.2.1 Inspecting the Storage Array (DSSI VAXcluster)

This procedure describes the steps to inspect the DECarray for correct

conﬁguration.

Inspection the DECarray from the front, then from the rear.

At the front of the DECarray:

a. The DSSI ID switches behind the door of the OCP of every SF7x enclosure

installed are set according to Table D–3 and Figure D–7.

b. The MSCP switch (right-most switch of each switch pack) should be in the

down or enabled position at all times unless you are instructed to change it

to the up or disabled position.

D–14 Installing a DECarray with VAX 4000 Systems

1 2 ... 301 302 303 304 305 306 307 308 309 310 311 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 306