Manx SA7x Guía de instalación descargar pdf (Pagina 35)

2.1 Unpacking and Placing the Storage Array

• Loose, missing, or broken ramp side rails

• Loose, missing, or bent metal hardware

If any of these defects exist, DO NOT USE THAT RAMP. Investigate

alternate means of removing the array or order a new ramp. The part

number for the left ramp is 99–07689–01; the part number for the right

ramp is 99–07689–02.

Use the following procedure to remove the array from the shipping pallet (see

Figure 2–2):

1. Remove the two unloading ramps.

2. Remove the cardboard carton and packing material.

3. Examine the equipment for physical damage.

4. Remove the shipping bolts (see Figure 2–1).

5. Remove the shipping brackets from the cabinet levelers.

6. Extend the ramp to its full length, and insert the steel dowel as shown in

Figure 2–2.

7. Position the unloading ramps on the pallet by ﬁtting the grooved end of

each ramp over the metal mating strip on the pallet.

8. Screw the cabinet levelers all the way up until the storage array cabinet

rests on its rollers on the pallet.

9. Loosen the locking nuts on all four leveler feet.

10. Carefully roll the array down the ramps. Three people are required to

unload the storage array from the shipping pallet (see Figure 2–3).

Unpacking and Repacking a DECArray300 Storage Array 2–3

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 35