Manx SA7x Guía de instalación descargar pdf (Pagina 62)

3.15 Right Position Guide Rail Plate Installation

c. While supporting the guide rail plate against the cabinet rear vertical

upright, extend the mounting bracket to engage the two front round

stand-offs into hole numbers 6 and 19 on the cabinet front vertical

upright.

d. From the front, insert and tighten the three shoulder screws and

lockwashers in mounting holdes 5, 12, and 18.

e. From the rear, insert and tighten the three shoulder screws and

lockwashers in mounting holes 5, 12 and 18.

f. Tighten the four ﬂathead mounting bracket screws as shown in

Figure 3–4.

3.16 Chassis Rail Installation (Universal Rails)

Note

Two types of guide rails are available: universal and Radio Electronics

and Television Manufacturer’s Association (RETMA).

To allow the length of the chassis rail to be adjusted to ﬁt the cabinet, one

end of the rail is extendable using a sliding rail bracket. One round standoff

on each end of the guide rail plate is used to locate the chassis rail along the

vertical cabinet rails. The round standoffs are inserted into front and rear

chassis rail locating holes to position the chassis rail while it is fastened to the

cabinet.

Note

Standoff location holes, front and rear, both sides, are holes 17, 35,

and 53 as shown in Figure 3–6. Two small ESD grounding posts are

provided with the cabinet. One is located on a front vertical cabinet

rail, and one on a rear rail. Should an ESD grounding post interfere

with the installation of the chassis rail, move the post out of the way to

any free hole on the cabinet.

3–20 Preparation and Installation

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 62