Manx SA7x Guía de instalación descargar pdf (Pagina 74)

3.17 Placing the Add-On Storage Element into the Cabinet

Note

Make sure the internal SDI/DSSI cables and drive power cables are

clear for storage element installation.

m. Remove the safety strap from the storage element and slide it into

the cabinet, making sure that the grooves on the side of the storage

element align with the cabinet guide rails.

n. Move the lifting device away from the cabinet. The cabinet guide rails

will support the weight of the storage element.

o. Slide the storage element completely into the cabinet frame.

p. Slide the Storage enclosure completely into the cabinet until the chassis

stabilizer bracket or the mounting brackets on the drive meets with the

holes in the cabinet frame.

q. Align the hole in the upper chassis retainer bracket with the hole in

the cabinet frame refer to Figure 7–1.

r. Insert the 10-32 x 5/8 pan-head Phillips sems screw (from the add-on

kit bag) through the upper chassis retainer bracket hole and into the

frame. Screw down, but do not tighten at this time.

s. Align the previously removed, clear plastic grille mounting bracket(s)

to the frame. Loosely secure the bracket to the frame by placing the

pan-head screw into the top bracket hole.

t. Align the holes in the lower chassis retainer bracket (L-shaped bracket)

and the clear plastic grille mounting bracket with the hole in the

cabinet frame refer to Figure 7–1. Insert the 10-32 x 5/8 pan-head

Phillips sems screw (previously removed) through both parts (clear

plastic grille mounting bracket and the chassis retainer bracket) and

secure, but do not tighten, to the cabinet frame.

u. If installing disk drives in upper or lower levels, align the two holes in

the chassis stabilizer bracket with the threaded holes in the cabinet

(H-stiffener) frame (above drives 5 and 6, below drives 3 and 4). For

installing the Sx7x or the Tx8xx you don’t need the chassis stabilizer

bracket.

v. Insert the two 10-32 x 5/8 hex serrated screws through the chassis

stabilizer bracket and into the frame.

w. Tighten all screws.

3–32 Preparation and Installation

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 74