Manx SA7x Guía de instalación descargar pdf (Pagina 149)

5.3 Powering Up the SF7x

Follow these steps to apply power to a newly installed SF7x storage enclosure:

CAUTION

Make sure that the drive dc power switches on the front of the

enclosure are in the out position.

1. Turn the ac power switch on the rear of the enclosure on. If the green

power supply fault light emitting diode (LED) is lit, see Chapter 8.

2. Press each of the four (4) drive dc power switches on the front of the SF7x

enclosure, one at a time. If the green LED on the drive dc power switch

does not light, see Chapter 8.

3. Observe the OCP indicators for each drive. If the Ready indicator is lit and

no other LED comes on and stays on, the drive has passed the power-on

self-test (POST). Should the Ready indicator not come on and the red Fault

indicator come on, see Chapter 8.

4. Press each of the four (4) Ready buttons, one at a time. The Ready

indicator should be on and stay on, with the Fault indicator remaining off.

If a fault occurs, refer to Chapter 8.

Once these steps are done and the drive has passed POST, then — and only

then — should you proceed to the next section.

5.3.1 Updating the System Conﬁguration Sheet

Now that the enclosure has been successfully installed, power has been

applied, and the drives have passed POST, you are ready to update the system

conﬁguration sheet to add the new ISEs.

Refer to the KFMSA Module Installation and User Manual (EK–KFMSA–IM)

for complete details on how to ﬁll out a system conﬁguration sheet.

5.4 Labeling the DSSI Cables and OCP

For a single-host conﬁguration, use the following colored labels on the SF7x

OCP door, magazine tape subsystem front panel, and all DSSI cables:

Installing the SF7x Storage Enclosure in an Sx300 Storage Array 5–43

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 149