Manx SA7x Guía de instalación descargar pdf (Pagina 57)

3.12 Installing Cabinet Hardware

3. Attach the top and bottom chassis retainer brackets (L-shaped brackets)

to the site of the disk drive using the short 10-32 x 3/8 pan-head Phillips

sems screws (from the plastic bag that is part of the RA90/RA92 disk drive

add-on kit). Two screws will be used for each retainer bracket. The chassis

retainer bracket has screw slots for mounting to the storage enclosure.

These screw slots are required to line up the SDI and DSSI devices after

mounting. After mounting the bracket, push the bracket towards the

storage elements for SDI devices. Pull it in the opposite direction away

from the storage element for DSSI devices. After adjusting the bracket,

tighten the mounting screws.

3.13 Guide Rail Plate Installation (RETMA Rails)

Note

Two types of guide rails are available: universal and Radio Electronics

and Television Manufacturer’s Association (RETMA).

Two round standoff on each end of the guide rail plate are used to locate

the guide rail plate along the cabinet vertical uprights. The round standoffs

are inserted into front and rear cabinet vertical upright mounting holes to

position the guide rail plate while it is fastened to the cabinet. Guide rail plate

installation procedures for both left and right enclosure mounting positions are

presented in Section 3.14 and Section 3.15.

If an ESD bolt is mounted to the vertical upright in your selected installation

position, remove the ESD bolt until your installation is complete, then fasten it

to an open space on the cabinet vertical upright.

3.14 Left Position Guide Rail Plate Installation

Install the guide rail plate in the left position within the cabinet as follows (see

Figure 3–4):

Preparation and Installation 3–15

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 57