Manx SA7x Guía de instalación descargar pdf (Pagina 214)

A.2 Cabling Diagrams

Table A–5 (Cont.) Cabling Diagram List

Dual-Host Conﬁgurations

Sx300 with one SF7x element Figure A–8

Sx300 with two SF7x elements Figure A–9

Sx300 with three SF7x elements Figure A–10

Sx300 with four SF7x elements Figure A–11

Sx300 with ﬁve SF7x elements Figure A–12

Sx300 with six SF7x elements Figure A–13

Sx300 with tape magazine elements only Figure A–14

A.3 Single-Host Conﬁgurations

This section contains cabling diagrams for Sx300 storage array variations in

the single-host conﬁguration. See Figure A–1 through Figure A–7.

Note the following:

• DSSI bus termination is supplied by the TTM module inside the SF7x

storage enclosures in position 3 and 5.

• The SF7x storage enclosures in positions 3 and 5 must be operating in

split-bus mode.

• If a DSSI bus is not connected to a SF7x storage enclosure in position 3 or

5, then DSSI bus termination is accomplished by using a DSSI terminator

(part number 12–31281–01).

• Split-bus mode is supported only in the single-host conﬁguration.

A–6 SF300 DSSI Storage Array Cabling Diagrams

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 214