Manx SA7x Guía de instalación descargar pdf (Pagina 207)

8.2 Troubleshooting the Magazine Tape Subsystem

• Poor power or grounding

Note

Make sure that any problem you encounter is not due to the above

causes before you replace the drive.

Table 8–4 Common Failures, Causes, and Fixes

Symptom Probable Cause Possible Fix

Volume not software enabled Drive is not loaded or was

unloaded by software

Make sure that the

yellow LED is on (tape

loaded and ready for

use).

TK50 formatted cartridge in

a TK70 drive

Use correct cartridge.

Bad cartridge or incorrectly

written calibration tracks

Try another cartridge.

Bad drive or dirty head Clean head and/or

replace drive.

Failure to mount or initialize

with new media

Bad media Clean head and retry

with known good

media.

All three LEDs blinking Drive failed self-test or

detected a hard error during

operation

Attempt to clear error

by pushing the unload

button. If the error

won’t clear, you have a

drive hardware failure

or a power problem.

Green LED blinking Calibration error Clear error by

pressing the unload

button. Try another

cartridge. If the error

repeats, you have

a drive hardware

failure or more than

one bad cartridge

(physically damaged

or bad calibration

tracks).

(continued on next page)

Installation Troubleshooting 8–15

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 319 320

Comentarios a estos manuales

Sin comentarios

Manx SA7x Guía de instalación Pagina 207

Comentarios a estos manuales

Relacionado con productos y manuales para Cajas eléctricas Manx SA7x