Manx SA7x Guía de instalación descargar pdf (Pagina 184)

7.2 SA300/H9643 Cabinet System Installation

• VARIATION L2 IS THE MOUNTING KIT FOR RA9X IN THE SX3XX 42"

CABINET.

7.3 Add-On of SDI Disk Drive Installation

The disk drive mounting guide rails have been installed at the factory for

each storage enclosure mounted in the original cabinet conﬁguration. The disk

drive mounting hardware will be located in two places: in the add-on shipping

container and attached to the front of the cabinet frame. Before proceeding

with the add-on installation, make sure all add-on disk drive and cabinet

hardware is available. See Section 7.3.1.

7.3.1 Hardware Check list

Following is a complete list of hardware needed to install and secure the disk

drive in the cabinet. Refer to 7–1:

1. RA90–NA/RA92–NA hardware:

• Chassis retainer brackets (2), for attaching the RA90/RA92 disk drive

to the cabinet frame.

• Short 10-32 x 3/8 pan-head Phillips sems screws (4), two screws for

each chassis retainer bracket (for holes on the side of the RA90/RA92

disk drive).

• Short 10-32 x 7/16 ﬂat-head Phillips screws (2), for attaching the

chassis stabilizer bracket to the top of the RA90/RA92 disk drive.

CAUTION

It is important to use the correct screws here, to avoid damage to disk

drive modules.

2. DECArray300 cabinet hardware:

• Long 10-32 x 5/8 pan-head Phillips sems screws (2), one for each

retainer bracket (for drive-to-frame connection, located on the cabinet

frame).

• Chassis stabilizer bracket (1), one per drive for disk drive positions 1,

2, 5, and 6. This bracket will be attached to the cabinet frame with two

10-32 x 5/8 hex serrated screws.

7–4 Installation and Preparation of the Add-On SDI Storage Elements

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 184