Manx SA7x Guía de instalación descargar pdf (Pagina 34)

2.1 Unpacking and Placing the Storage Array

Remember:

Retain the shipping container and all packing materials.

CAUTION

Failure to stabilize the equipment thermally may damage the drive

media or associated electronics when the unit is powered up.

Remove the outer shipping carton, but leave the sealed moisture barrier with

desiccant in place for at least 24 hours (thermal stabilization time). Thermal

stabilization begins when the equipment is placed in the room where it is to be

installed.

WARNING

Adhere to electrostatic discharge (ESD) procedures at all times. Use

the ESD straps available with every storage array. The strap is inside

the rear door. See Section 3.3.

Once the storage array is unpacked, examine the front and rear, the right

and left side panels, and undercarriage for any apparent damage. Report any

damage.

2.1.2 Removing the Sx300 Storage Array from the Pallet

This section provides the procedure for removing the storage array from the

pallet and leveling the array. For personal safety, adhere to the following

WARNING before starting the procedure:

WARNING

Serious personal injury may result if correct safety conditions are not

met. During the unpacking procedure, personnel should wear safety

glasses. Inspect the ramps, ramp side rails, and metal hardware for

the following defects:

• Cracks more than 25 percent of the ramp depth, either across or

lengthwise on the ramp

• Knots or knotholes going through the thickness of the ramp and

greater than 50 percent of the ramp width

2–2 Unpacking and Repacking a DECArray300 Storage Array

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 34