Manx SA7x Guía de instalación descargar pdf (Pagina 61)

3.15 Right Position Guide Rail Plate Installation

Install the guide rail plate in the right position within the cabinet as follows

(refer to Figure 3–4):

WARNING

Cabinet vertical upright edges may be sharp and can slice or abrade

skin or cable insulation.

1. Turn the cabinet power off.

2. This procedure installs an enclosure in add-on sequence position 5. Refer

to Table 3–1 to select the optimum add-on sequence position for your

installation.

3. Remove the rear access panel.

4. Remove the bezel ﬁller that corresponds to add-on sequence position 5.

a. Remove the bezel. See Section 3.4.

b. Remove the U-clips securing the bezel ﬁller to the bezel.

c. Remove the bezel ﬁller.

WARNING

Use care in supporting the guide rail plate. It is heavy and awkward to

position within the cabinet. If possible, use two persons to support and

position the guide rail plate. The guide rail plate may cause personnel

injury if dropped during installation.

5. Install the guide rail plate in add-on sequence position 5. Add-on sequence

position 5 corresponds to mounting hole numbers 5, 12 and 18 as shown in

Figure 3–5.

a. From the front of the cabinet, position the guide rail plate with the

mounting bracket to the front, making sure that the arrow on the

mounting bracket is pointing up.

b. Insert the two rear round stand-offs into the cabinet so that hole 12

becomes the center mounting hole in the guide rail plate.

Preparation and Installation 3–19

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 319 320

Sin comentarios

Manx SA7x Guía de instalación Pagina 61