Manx SA7x Guía de instalación descargar pdf (Pagina 44)

Chapter 5

Powering Up the SA7x Enclosure

This chapter explains how to use the SA7x enclosure and drives and how to set the unit

number.

5.1 Powering Up the SA7x Enclosure

Apply power to the enclosure as follows:

1. Verify that the drive power switches on the front panel of the enclosure are set to off

(switch button released).

2. Set the master on/off switch to 1.

3. Verify the power is on by checking that the fan starts and normal airﬂow exists through

the enclosure.

Note

Air may ﬂow through the enclosure without output voltage. This indicates the line

voltage select switch is in the wrong position. Set the master on/off switch to 0 and

set the line voltage select switch to the correct switch setting.

5.2 Placing a Drive On Line

After applying power to the SA7x enclosure, power up and bring each disk drive in the

enclosure on line by performing the following steps:

1. Locate the drive power switches. Refer to Figure 4–1.

2. Press the drive power switch for the desired drive. If power to the drive is within

speciﬁcations, the green switch element indicator illuminates.

Note

Setting a disk drive power switch does not spin up the associated drive.

Powering Up the SA7x Enclosure 5–1

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Sin comentarios

Manx SA7x Guía de instalación Pagina 44