Manx SA7x Guía de instalación descargar pdf (Pagina 28)

12. Install the washer (90–06637–00) and shoulder screw (12–24007–01) through the bottom

hole of the chassis retaining bracket and into the middle hole of the shim (hole 3 of the

cabinet upright). The shoulder screw is torqued to 30-inch pounds.

13. Torque the three rear screws on the rail-mounting assembly to 30-inch pounds.

14. Torque the four screws (90–00039–26) shown in Figure 3–6 holding the bracket rail

assembly to the guide rail assembly to 30-inch pounds.

3.7 Installing the SA7x Enclosure into the Cabinet

Although the VAX 6000 series cabinet allows installation of the SA7x options into either the

right or left side of the disk cavity, it is recommended that the ﬁrst option be installed into

the left side of the cavity (from the front of the cabinet). Use the following procedure to install

the SA7x enclosure into the VAX 6000-series processor cabinet:

CAUTION

The SA7x enclosure power supply is universal for both 120 Vac at 60 Hz or 240 Vac at

50 Hz. The power supply is set to 240 Vac at 50 Hz at the factory and must be reset

to 120 Vac at 60 Hz for some installations. Selecting 120 Vac at 60 Hz and using 240

Vac at 50 Hz will damage the supply.

Note

The chassis retainers and screws used in this procedure are in the SA7x enclosure

add-on kit, not the SA70–CK installation kit.

1. Grasp the middle of the SA7x enclosure operator control panel and pull it out.

2. Attach the front top and bottom chassis retainers (74–35858–01) to the SA7x enclosure,

using the four (two per chassis retainer) 10–32 x 3/8 sems screws (90–09228–10). Refer

to Figure 3–8.

3–14 Installing the SA70–CK Kit

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Sin comentarios

Manx SA7x Guía de instalación Pagina 28