Manx SA7x Guía de instalación Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 52
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
3. Lift and move the SA7x enclosure into place using a Digital lifting device (FC–10117–AC).
WARNING
If a lifting device is not available, two people are needed to install the SA7x into
the drive cavity. The SA7x weighs 40 kilograms (88 pounds) and must be handled
with care.
4. Slide the SA7x enclosure into the cabinet on the guide rail.
5. Set the line voltage select switch, located at the rear of the SA7x enclosure, to the correct
volt/amp setting.
3.7.1 Securing the SA7x Enclosure
Use the following procedure to secure the SA7x enclosure:
1. Secure the SA7x enclosure to the rail by installing 10–32 x 5/8-inch flathead Phillips
screws (90–06074–02) through the top and bottom chassis retainers and into the top and
bottom chassis retainer brackets, as shown in Figure 3–8. Ensure spacing between the
SA7x operator control panel and shielding is even across the front. Tighten the screws
accordingly.
2. Install the flat washer (90–06664–00) and 10–32 x 5/8-inch pan-head sems screws (12–
21368–02) into holes 2 and 17, through the top and bottom chassis retainers, and into
the guide rail plate assembly. Tighten the screws. Refer to Figure 3–8.
3.7.2 Installing the Rear Clamping Assembly
Install the rear clamping assembly as follows:
1. Slide the rear retainer chassis bracket (74–35860–01) into the SA7x enclosure chassis, as
shown in Figure 3–9.
2. Insert the following parts, in order, through the retainer chassis bracket and into hole 17
of the cabinet upright:
White nylon wedge block (74–36160–01)
Flat washer (90–06664–00)
Helical washer (90–07906–00)
Pan-head Phillips screw (90–06078–01)
3. Tighten the pan-head screw to secure the rear of the enclosure to the cabinet upright.
4. Repeat these steps for the bottom rear clamping assembly, installingthe assembly through
hole 3 of the cabinet upright.
3–16 Installing the SA70–CK Kit
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Comentarios a estos manuales

Sin comentarios