Manx SA7x Guía de instalación descargar pdf (Pagina 23)

3.6.3 Installing the 74-39405-01 BeCu Spring Clips

Use the following procedure to install beryllium copper (BeCu) spring clips:

1. Install one BeCu spring clip (74–39405–01) under the front edge of the BBU shielding

tray. Refer to Figure 3–5.

2. Install the other spring clip on top of the front of the cabinet base. Refer to Figure 3–5.

The spring clip hem faces the front of the unit so that the clips compress when an enclosure

is installed.

3. Peel the adhesive strip off the back of the spring clips and adhere them 0.5 inches from

the cabinet upright and 0.25 inches from the cabinet front.

3.6.4 Installing the Guide Rail Plate Assembly

Locate the preassembled guide rail plate assembly in the SA70–CK kit. This assembly

consists of:

• Rail chassis assembly (70–25686–01)

• Bracket rail assembly (70–25687–01)

• Insert nut bar (74–36464–01)

• Four screws (90–00039–26)

To install the guttural plate assembly:

1. Slide the guide rail plate assembly into the cabinet on the appropriate side. The guide

rail plate assembly mounts from the inside of the cabinet uprights.

Note

The guide rail plate assembly is marked with an up arrow for proper installation.

Ensure the arrow on the rail sheet metal is pointing up when installed. The

up arrow should be visible to the installer after the guide rail plate assembly is

installed. Also, the bracket rail assembly (70–25687–01) will be in the front of the

cabinet for SA7x installation into the right side of the cabinet. The bracket rail

assembly will be in the rear of the cabinet for SA7x installation into the left side

of the cabinet.

2. Go to the back of the cabinet. Count four holes up from the bottom of the cabinet upright.

Note

All references to holes refer to the cabinet upright mounting holes. Always start

counting from the bottom of the cabinet upright.

3. Insert the bottom rear standoff of the guide rail plate assembly through hole 4.

4. Insert the top rear standoff of the guide rail plate assembly through hole 15. Standoffs

through these holes hold the guide rail plate assembly in place.

Installing the SA70–CK Kit 3–9

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Sin comentarios

Manx SA7x Guía de instalación Pagina 23